MustangWorks.com : Ford Forums - View Single Post

Hatem Ghandour · 12-10-2004, 10:00 PM

I got a 96 GT and im in process doin the PI intake swap...i bumped into a couple of problems..first off the pI gasket is not the same as the lower intake and there are little stubs on them that are supposed to go into the lower intake but they don't line up...wat do i do about that and the most important thing one of the coolant sensors taht goes on top of the thermostat housing , theres no spot for it on the new PI intake..what do i do about that??

and wat else will i bump into durin the swap??

12-10-2004, 10:00 PM	#1
Hatem Ghandour Registered Member Join Date: Dec 2004 Posts: 1	Pi Intake Problems!! I got a 96 GT and im in process doin the PI intake swap...i bumped into a couple of problems..first off the pI gasket is not the same as the lower intake and there are little stubs on them that are supposed to go into the lower intake but they don't line up...wat do i do about that and the most important thing one of the coolant sensors taht goes on top of the thermostat housing , theres no spot for it on the new PI intake..what do i do about that?? and wat else will i bump into durin the swap??