MustangWorks.com : Ford Forums - View Single Post

Faded · 07-01-2003, 06:37 PM

I know this is in the wrong forum, I posted in the Small Ponies forum but it doesn't look like there is much traffic, so I was hoping someone here would please help a newbie out;

I have a check engine light on my '94 convertible V6. My question is how do I pull the codes? I found a 16 pin connector behind the center console on the drivers side (it only has 6 pins in it). I'm assuming this is where you terminate to pull the codes, but I'm unsure which pins need to be jumpered (if these are the right ones). Someone please advise?! Any help is apreciated.

Thanks in advance,
Andrew

07-01-2003, 06:37 PM	#1
Faded Registered Member Join Date: Jul 2003 Posts: 5	PLease Help: Retrieving Fault Codes I know this is in the wrong forum, I posted in the Small Ponies forum but it doesn't look like there is much traffic, so I was hoping someone here would please help a newbie out; I have a check engine light on my '94 convertible V6. My question is how do I pull the codes? I found a 16 pin connector behind the center console on the drivers side (it only has 6 pins in it). I'm assuming this is where you terminate to pull the codes, but I'm unsure which pins need to be jumpered (if these are the right ones). Someone please advise?! Any help is apreciated. Thanks in advance, Andrew