MustangWorks.com : Ford Forums

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)
-   Windsor Power (http://forums.mustangworks.com/forumdisplay.php?f=8)
-   -   Have fuel leak somewhere, new regulator and new injectors.. (http://forums.mustangworks.com/showthread.php?t=2143)

88GT5.013.02 04-02-2001 03:09 PM

Have fuel leak somewhere, new regulator and new injectors..
 
Well I have a fuel leak somewhere and I haven't found it yet. I have a new fpr and new injectors.

When you turn the key it initializes pressure, but the system doesn't hold the pressure.

I was told by someone on this website that some fuel pumps relieve the pressure and don't allow it to sit with pressure. I have a Holley 190 lph.

The guage I have on my schrader valve looks like it is wet, but I tightened it the other day. That didn't help. I will check the fuel filter and I will probably drop the tank and make sure everything is alright back there.

I don't smell gas, I just don't like that my fuel system won't hold fuel pressure like it is supposed to. I just put on an Aeromotive fpr.

Any help is greatly appreciated.

Thanks,

Jason

egiap's 5.0 04-02-2001 05:27 PM

where the gauge screws onto the fuel line. there is a plastic washer in it. by over tightening you might have damaged that plastic seal. i should know, i did the this very thing to my gauge. hope this helps

88GT5.013.02 04-03-2001 08:57 AM

Thank you I will check that out. Where do I get that little plastic washer if it is crushed, the Ford Dealer? Once again thanks.

Anyone else on any other possible causes.

------------------
88GT stock shortblock, GT-40 iron heads, Edlebrock Performer intake, 24# inj, Pro-M 75mm Bullet MAM, 3.73, hurst short throw, F-303, electric fan, alum rad, FMS HD clutch, R134a ac conversion, 70mm TB , and some other stuff I probably forgot, 13.02@106 with a 1.87 60ft

gray87GT 04-03-2001 03:02 PM

Is the fuel system leaking, or is the FPR not holding it? With my BBK AFPR when I turn the key the system charges to the right pressure but doesn't hold it, my gauge goes back down...but I don't leak fuel.

88GT5.013.02 04-03-2001 07:10 PM

I have a brand new Aeromotive fpr, is it supposed to bleed back? I don't think they are but I could be wrong. I don't see any gas leaks, and I don't think I have any, but I will look further. Any other suggestions, anyone else?

Thanks,

Jason

Doctor DeBo 04-03-2001 07:29 PM

Ive got a Aeromotive fuel sys and it doesnt hold pressure either,it bothered me for a while until I found out that was normal.If the car runs ok I dont think I would be too concerned.

88GT5.013.02 04-04-2001 12:04 AM

Thanks I appreciate the help doc debo.

Jason


All times are GMT -5. The time now is 07:38 PM.