MAF and TB
 

What MAF and what throttle body should I go to on the ol' 4.6? I don't have a supercharger on it (for right now http://216.59.112.100/interactive/msgboard/smile.gif). Stock heads and intake. Thanks

------------------
1996 Mustang GTS
K&N, removed air silencer, 3.55s, turndowns after H-pipe (no mufflers)

Your 4.6L comes with a stock 80mm MAF, which is a great size. However, there is a post in the middle which takes up a lot of space. If you go to mustangworld.com, there are instructions to remove to post with a hacksaw and a dremel tool in their "How-to" section. Thats what I did, and it worked great.
As far as the TB, 70mm is a good size. There are instructions at mustangworld for that too.

------------------
96' GT
5-speed,K&N air filter,removed air silencer,80mm MAF,Mac True Fit Cat-Back
http://minot.com/~topel/stang9.JPG

[This message has been edited by T-Bone (edited 03-22-2000).]

Yeah, I did the post cut & TB first as well. Works well but you'll need a new MAF when you go Supercharged. Trust me, It's worth the $!

------------------
96GT, Vortech S-Trim,C&L 80mm mass air,30# injectors, MSD DIS-4, 3.73, Bassani X, Flows, 70mm TB, Subs, Mega-Bite Jr.Lower rear Ctrl Arms, FMS Uppers, Ripper, and a bunch of other $tuff I can't seem to remember!