Oh my...
I would be staying away from there like the plaque.
A decent tech should be able to handle the job within about 2 to 3 hours. (Depending on how busy they are at the time)
The 350 I quoted was for the entire job minus tax, so you would have to tack that on also. But it is still quite a bit cheaper than what you were quoted.
These guys are either unfamiliar with this type of stuff or its possible that they're trying to tack on some bucks under the "labor" department....
Either way, not a good situation. ;-)
Personally, I would look elsewhere...
------------------
98 GT
Dyno-Max cat-back exhaust, 3.73 gears, Steeda shifter, Ford Motorsport Underdrive pullies, 87mm MAF and Roush cold air kit...
[This message has been edited by Hammer (edited 02-17-2000).]
|