MustangWorks.com : Ford Forums

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)
-   Modular Madness (http://forums.mustangworks.com/forumdisplay.php?f=17)
-   -   Reliable Zex nitrous results are in!! (http://forums.mustangworks.com/showthread.php?t=13726)

Hammer 05-31-2000 11:31 PM

Reliable Zex nitrous results are in!!
 
And they're not too bad...

ET before Zex and X-pipe:
14.97 at 94.02

ET after:
14.18 at 100.02

Gain of .79 seconds and 6 MPH

Hope this helps...

------------------
98 GT
Bassani X-pipe, Dyno-Max Cat backs, 3.73 gears, Steeda shifter, FMS pullies, 87mm MAF, Roush cold air kit, Eibach springs, and Zex 75 shot

Red94Z 06-01-2000 10:26 AM

Impressive.
Thanks for posting the results.
Something I'll have to look into for the 'lil GT

paver one 06-02-2000 01:27 PM

Read the March issue of MM & FF. They installed the ZEX system on a GT and got an additional 70 rwhp. I run the 75HP ZEX juice on a 1996 s281 SALEEN and love it.....

------------------

Cobra98conv 06-03-2000 12:22 AM

Looks good!

I'm ordering a ZEX system for my Cobra this week (with wife's approval even). Actually I can't wait.

I figure a 75 shot will hurl me well into 12s.

How long was the install?

------------------
1998 Triple blk Cobra Convertible
4.10 gears, ASP pullies, Bassanni X-pipe, Steeda subframe , Tri-Ax shifter, UPR Powerpipe, 80mm Pro-M
Best ET 13.59 @ 103.2mph (2.1 60')

paver one 06-06-2000 02:11 PM

It took me a couple of hours to install with having to route the line from the bottle in the trunk to the engine compartment. Also check to see if you can put a couple of thin washers on either side of the injector nozzle that goes into the air intake. I didn't like the idea of tightening the fittings onto rubber.....Good luck, let me know how it goes........

------------------


All times are GMT -5. The time now is 05:25 PM.