sensors on pi swap
 

i ran into a problem with my swap my 96 intake had the two sensors up front and the pi only has the one? so and ideas about what i do with the other one i have heard to tap it but where? anywhere or is there any other alternatives on what i can do and suggestions would be appreciated thanx guys :confused:

Re: sensors on pi swap
 

I just ran into the same problem this past winter when i was doing a pi swap on my motor. im a ford tech so i had some insight on why.in 99 ford decided to multiplex the two sensors to 1 and thus for us pi swapers we have to tap our intake. if you have the aluminum intake crossover and you should. there is a perfect flat spot by the t-stadt elbow . its a pipe thread and drills very easy.good luck


96 gt pi conversion stage 2 crower cams ported and polished heads headers h-pipe balancer pulleys 80 mm mass air 75 mm t-body cl inlet pipe and many many more goodies!!!!!!!!!

Re: sensors on pi swap
 

ya i just noticed today actually that spot but wasnt sure thanks for the reply