[Hammer]

If you are going to go that route, you might as well do the 99+ head\intake swap... and if the price is right, go with the Bullit intake.

Be sure to get all the "extra" parts you will need, as this will not be a direct bolt-on affair. Unfortunately, I don't have a list, but I have seen it posted once or twice on corral.net.

Personally, I've seen enough plastic intakes go bye-bye (even the 99+ units), that I would always opt to go with an all-aluminum piece when using forced induction.

But the stock 99+ units seem to work much better than the "flawed" 96-98 intakes.

Good luck!