[explicitone]

ok where to start

#1 I ran a 14.1@99 stock

#2 at 13.99 you will need a 4 point roll bar at most tracks(not cage cages are not needed for awhile)

#3 just do a drop in k&N (cai are junk the bend in front of the maf causes problems) and get a densecharger maf t/b pipe cost 60$ shipped plus you dont need to heat wrap that or the stock cause they dont get hot its the metal ones that need to be wrap

#4 it has been dyno proven not to add anything but noise on the old 5.0s it did 87-93 cause of the small airbox in the fender

#5 and as I said in the other thread it will not harm it you will just need to clean it every few months with elec. contact cleaner

#6 heat wrapping the stock pipe is a waste of money