Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-26-2003, 08:33 AM
|
#1 |
|
Registered Member
Join Date: Dec 2002
Location: Philadelphia PA
Posts: 143
|
Trans part question of the day
 Above is a link to a picture of the T45 trans out of a 99 Cobra. There is a #50 torque tip bolt located above and forward of the reverse light switch electrical connector. What is this bolt for?
__________________
2000 GT 80mm Pro-M mass air, 24lb injectors, 75mm BBK T/B, K&N Filter Cold Air, 1/2" Phenolic intake spacer, Underdrive Pulleys, Dyno Tuned Autologic Chip, FMS Shorty Headers, Mac Prochamber 2 1/2" Off Road H pipe, 2 Chamber Flowmasters, Steeda lowering springs. Steeda Tri-Ax Short Throw shifter, Steeda Power slot rotors w/ Hawk Pro pads, 3.73 FRP Gears. Headwork and Comp cams install in progress. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trans Question | kvaught | Windsor Power | 3 | 11-14-2003 01:02 PM |
| Auto Trans Question | 93CougarXR7 | Windsor Power | 2 | 08-04-2002 02:10 PM |
| Auto Trans Cooler Question | NewStang02 | Small Ponies | 2 | 06-18-2002 07:58 PM |
| trans mount question, need opinions | avbcon12 | Windsor Power | 6 | 04-07-2002 09:09 PM |
| auto trans part in pan | delrrex | Windsor Power | 3 | 09-03-2001 02:37 PM |