Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
05-12-2000, 06:04 PM
|
#1 |
|
Registered Member
Join Date: Jul 1999
Location: rocky point, NY ,USA
Posts: 65
|
Oil leak w/new pullies
just got my steeda pullies in yesterday and I notticed that a small amount of oil is leaking out of the center of the crank pully where the bolt is.Is this just not on tight enough or something worse?
------------------ 1999 GT AOD,FMS 70MM TB,Steeda pullies,Dynomax Super Turbos,MAC cold air kit,Steeda strut tower brace,ATS-III seq. turn signals |
|
|
|
05-13-2000, 02:11 AM
|
#2 |
|
Registered Member
Join Date: Apr 2000
Posts: 2
|
Did you forget to put the high-temp sealant in the keyway?
|
|
|
|
|
05-13-2000, 03:02 AM
|
#3 |
|
Registered Member
Join Date: Jul 1999
Location: rocky point, NY ,USA
Posts: 65
|
I had it done and I helped and I saw the tube of sealent out but I dont know if it made its way to the pully.Good place to start. Thanks!
------------------ 1999 GT AOD,FMS 70MM TB,Steeda pullies,Dynomax Super Turbos,MAC cold air kit,Steeda strut tower brace,ATS-III seq. turn signals |
|
|
|
|
05-14-2000, 12:43 AM
|
#4 |
|
Registered Member
Join Date: Jul 1999
Location: rocky point, NY ,USA
Posts: 65
|
It was a bad crank seal.$7.80 part and no more leak!
------------------ 1999 GT AOD,FMS 70MM TB,Steeda pullies,Dynomax Super Turbos,MAC cold air kit,Steeda strut tower brace,ATS-III seq. turn signals |
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| vaccum leak? | 94snake | Windsor Power | 11 | 08-05-2004 02:35 AM |
| Vacuum leak?? | daccrow86 | Classic Mustangs | 4 | 10-20-2003 10:25 AM |
| Help!! Exhaust Leak | 1991GT | Windsor Power | 5 | 12-13-2002 09:39 PM |
| Fuel Filler Leak HELP!! HURRY!! | manycars23 | Windsor Power | 2 | 09-12-2002 09:33 AM |
| coolant leak, water pump maybe? | fiveohpatrol | Windsor Power | 4 | 02-04-2001 05:35 PM |