Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-03-2003, 11:43 AM
|
#1 |
|
Trisket
Join Date: May 2002
Location: University of Florida, FL Posts: ½
Posts: 1,560
|
piggyback pulley q - IMPORTANT!
what happens if the shop that installed the crank pulley (needed an airgun) didnt connect the old one to the new one (piggyback them) and just the new u/d crank pulley is running on there? doesnt the old pulley serve as a dampner? prolly be good to get an answer sooner rather than later, cuz if this is bad, itll need fixing.....
thanks -jonathon
__________________
University of Florida - Physics Major My 02GT vert Media Center Pics BBK Underdrive Pulleys | K&N FIPK (Gen II) | Bullet Grille | Mach 1 Chin Spoiler | UPR Interior Parts | XM Radio | Audiobahn Subs Ricer Hater's Club Member #1/2 (30) http://www.ricehatersclub.com/ Last edited by jj_jonathon; 06-03-2003 at 11:53 AM.. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 68 Mustang Engine Swap pulley problems | kirkdickinson | Classic Mustangs | 10 | 07-13-2008 07:45 PM |
| FMU and Supercharger Pulley Question | NitroNixon | Windsor Power | 3 | 05-14-2003 08:06 PM |
| Need an altenator pulley??? | Coupe Devil | Windsor Power | 4 | 04-01-2003 09:06 AM |
| Piggyback pulley problems! (long) | Mustang92 | Modular Madness | 3 | 01-16-2001 10:24 PM |
| water pump pulley | Mo65 | Classic Mustangs | 4 | 11-05-1999 02:55 AM |