2002 rev limit on 2 valve 4.6

MiracleMax · 12-17-2001, 10:01 AM

Heys whats the rev limiter set to on the sohc motors?

I pop mine a tad above 6000 rpm?

I've read that the Bob Bondurant cars had the rev limit adjusted from 7200 to 6800 rpm?

Looks like it might have been a misprint

Hammer · 12-17-2001, 10:30 AM

I think the rev limiter on the 2002 is the same setting as ours: a tad over 6 grand...

Mustang92 · 12-17-2001, 11:14 AM

It's the same as the 99-01 GTs 6250 RPMs.

The only way the bondurant cars could go that high would be with a DOHC motor otherwise it's a mis print. Our stock cranks can't handle revving to 7K.

Bill

blue00gt · 12-17-2001, 05:14 PM

The Bondurant cars are the Orange 96-98 Cobras with blue stripes and a star on them.

MiracleMax · 12-18-2001, 09:34 PM

Naw, these were 2 valve cars. I'm pretty sure it was a misprint

Ares · 12-18-2001, 11:26 PM

Yah 6250 sounds bout right. I sometimes hit it when I miss my 1st-2nd shift

12-17-2001, 10:01 AM	#1
MiracleMax Registered Member Join Date: Apr 1999 Location: Hayes, Va, USA Posts: 798	2002 rev limit on 2 valve 4.6 Heys whats the rev limiter set to on the sohc motors? I pop mine a tad above 6000 rpm? I've read that the Bob Bondurant cars had the rev limit adjusted from 7200 to 6800 rpm? Looks like it might have been a misprint __________________ 2002 5M GT (99% stock) 1991 5M LX (30% stock) patiently awaiting my satin silver 07 Mach 1, and don't forget the shaker

12-17-2001, 10:30 AM	#2
Hammer AKA "Dr. Evil" Join Date: Feb 1999 Location: South Fork Ranch Posts: 1,721	I think the rev limiter on the 2002 is the same setting as ours: a tad over 6 grand... __________________ Uncle Sam "What the hell is up with all the gauges? Calling Captain Kirk, your ride awaits... Phasers on stun...."

12-17-2001, 11:14 AM	#3
Mustang92 Drag Racer! Join Date: Nov 1999 Location: Lake Worth, FL USA Posts: 757	It's the same as the 99-01 GTs 6250 RPMs. The only way the bondurant cars could go that high would be with a DOHC motor otherwise it's a mis print. Our stock cranks can't handle revving to 7K. Bill __________________ 2000 GT VRS O/R X, Dynomax Bullets, Steeda Pulleys, Pro-M 80MM, 4.30s, UPR Pro Series Suspension, UPR Tubular K-member, MAC Longtubes, Bullitt Intake, TKO, VT Engine Stage 1 NA Cams, SCT Tune. 285 RWHP/296 RWTQ 11.97 @ 113.20 M/M 100, 7085 www.uprproducts.com www.ponyexpressperformance.com www.modulardepot.com

12-17-2001, 05:14 PM	#4
blue00gt Mustang Addict Join Date: Jan 2001 Location: McKinney, TX Posts: 1,294	The Bondurant cars are the Orange 96-98 Cobras with blue stripes and a star on them. __________________ Strike down the unroadworthy! 2000 GT Atl. Blue: '03 Cobra motor - 465rwhp/473rwtq, T-56 6-speed, full MM TA/PH & tubular K-member suspension, Saleen body, 17" Torq-Thrust II's, M/T ET Street radials, and lots more '94 Rio Red Cobra: All the bolt-ons, 3.73s

12-18-2001, 09:34 PM	#5
MiracleMax Registered Member Join Date: Apr 1999 Location: Hayes, Va, USA Posts: 798	Naw, these were 2 valve cars. I'm pretty sure it was a misprint __________________ 2002 5M GT (99% stock) 1991 5M LX (30% stock) patiently awaiting my satin silver 07 Mach 1, and don't forget the shaker

12-18-2001, 11:26 PM	#6
Ares Registered Member Join Date: Oct 2000 Location: Saxonburg, PA, USA Posts: 236	Yah 6250 sounds bout right. I sometimes hit it when I miss my 1st-2nd shift __________________ Ed.. My Mustangs webpage NMRA M/M 7222 2000 Mustang GT - 5 speed Race weight w/o driver 3086lbs, 3250 w/ driver Best 1/4mile run to date: 12.79@105.96, 60' 1.76sec.(10-27-02) Best MPH 106.03(10-27-02)4.10gears

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
valve problem	pearlgt40 306	Windsor Power	3	07-05-2003 01:21 AM
2002 valve cover gasket?	ponypower	Modular Madness	1	07-26-2002 05:22 PM
2002 GT vs 1987 GT Review LONG	Unit 5302	Blue Oval Lounge	11	06-09-2002 05:29 PM
Proportioning Valve	MidniteWrider	Classic Mustangs	1	07-11-2001 09:14 AM
PCV Valve what the ?@#$@#$@$	Chevyguy	Windsor Power	3	04-11-2001 08:01 PM