© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-26-2002, 07:26 AM | #1 |
Registered Member
Join Date: Jul 2001
Location: W. Keasnburg, NJ, USA
Posts: 14
|
Questions for all you Auto guys
I have a 2000 GT auto, I have a few questions. What trans is in the car? I thought it was AODE but now im not sure if its the 4r70w? What mods should I do to the car to be able to kick a stick? I have exhaust and Cold air kit now thats all. I eventually wanna supercharge the car. What gears should I use? Where can I buy a shift kit? Any good Torque converts? ANy otehr suggetions.
Thank you Sal |
01-26-2002, 10:03 AM | #2 |
Registered Member
Join Date: Aug 2001
Location: Long Island, NY
Posts: 71
|
You definitely need a good quality higher stall torque converter, trans cooler & 3.73 gears. You won't lose to the best driven manual car with those mods. Also you will want to do these mods before the supercharger. I had a V2 S-trim with a 3K stall converter, shift kit, cooler & Redline Synth. ATF and the car took off like a roots blown car spinning all the way through 2nd before the car rolled 20 ft. It was a violent setup. I would get a Protorque converter with about 2800 stall, shift kit, trans cooler, 3.73 gears & change the fluid while you are at it and enjoy the ride. Inspite of what some people would have you believe, the torque converter will change the rate of acceleration and power output to the ground.
__________________
99 Silver GT Auto DTA Built Engine w/P&P heads, TDC Turbo (T-76), Built 4R70W, PI Multi-Disc 3200 T/C, Eaton 31 Spline Carrier, Strange 31 Spline Axles, Aeromotive 1000 HP fuel system, 66lb injectors, MSD DIS4, Accel DFI Gen VII & Mac 3" cat-back. Built by Jade Performance Best on Nitto D/Rs 11.698 @ 120.898 @ 12 psi (built block) Best on Slicks 10.922 @ 122.95 (stock longblock) |
01-26-2002, 10:05 AM | #3 |
Registered Member
Join Date: Aug 2001
Location: Long Island, NY
Posts: 71
|
Oh, you are correct in saying that you have a 4R70W or AODE-W. The W just means wide-ratio because of the 2.84 1st & 1.55 2nd gear vs the 2.40 1st & 1.47 2nd found in the AOD & AOD-E.
|
01-26-2002, 03:11 PM | #4 |
Registered Member
Join Date: Jul 2001
Location: W. Keasnburg, NJ, USA
Posts: 14
|
Thanks guys for all the help, Just one more question =) where can I buy the Trans go shift kit and teh torque converter?????
Thanks |
01-26-2002, 04:32 PM | #5 |
Registered Member
Join Date: Jun 2000
Location: Nor-Cal
Posts: 1,311
|
With my setup, I have NO trouble on the street with the stick GT's.
If you're planning on boost, I would strongly recommend against steeper gears. The stock 3.27's will do nicely to hold off the excess tire spin you'd see with gears+boost. Good luck!
__________________
Black 2000 GT Auto V2-SQ, Full Steeda G-trac Suspension, Baer Brakes, Saleen Body Kit, Corbeau CR1s, Chrome Cobra R's, etc, etc... 341rwhp, 338 torque 1994 Cobra #4343 Bolt on's only... Cofounder of Raccoon Racing |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Some questions for all you S/C guys | Rosco | Windsor Power | 12 | 03-19-2002 10:21 PM |
Two questions | 5.0PiMpin | Windsor Power | 5 | 03-06-2002 05:40 PM |
Question for Auto Guys | HenDawg | Modular Madness | 6 | 03-05-2002 09:50 AM |
Let me know what u think guys, kinda long | ex-lt1-guy | Blue Oval Lounge | 2 | 03-04-2002 01:11 PM |
Questions: Just got my Paxton Novi 2000! | LfiveohX | Windsor Power | 8 | 02-12-2002 12:27 AM |