© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-15-2002, 09:38 AM | #1 |
Registered Member
Join Date: May 2002
Location: Detroit,Michigan
Posts: 1
|
More Power
Hi everyone just wanted to try and holla at yu need performance tips price range is noy a problem . All though I'm looking for some horsepower and low E.T. holla at me peace!!!!!
__________________
Ike O Gamble |
05-15-2002, 03:44 PM | #2 |
Registered Member
Join Date: Apr 2002
Location: Dublin Ohio
Posts: 28
|
Price not a problem??
Well if money isn't an issue, you could start with a full exhaust setup of your choice, supercharger, blower, intake manifold, heads, cam, crankshaft, tranny, nitrous, shocks/struts/springs, front&rear strut tower braces, under-drive pulleys, racing bushings and bearings, a lightweight driveshaft and flywheel, brakes, a new chip or a module....that's all that really comes to mind. I'm sure that someone else can elaborate a little bit more.
--Keck--
__________________
::HAD:: May She Rest In Peace... 1997 Mustang GT convertible Black w/ Tan Top& Interior JBA Headers&FRPP SVO sidepipes Superchip 17x9 Chrome Plated Cobra R Michelin Pilot Sport Tires Mustang Spyder Kit K&N Air Filtercharger Pioneer Premiere Faceplate 2-Pioneer 200watt 4-way amps 4-Pioneer 5x8 main speakers 2- Pioneer 10"subs Battery Relocation Kit Street Glow Red Underbody Neon Kit Steeda Tri-Ax short throw shifter Steeda Underdrive Pulleys Xenon Aero Side Scoops COMING SOON::TNT nitrous system!! Liscense Plate=IGO FAST --And what a kick *** ride! Totaled June 7th 2002 Looking For 94-98 GT Convert... |
05-15-2002, 05:06 PM | #3 |
Registered Member
Join Date: May 2000
Location: Kamloops, BC
Posts: 2,875
|
Power adders are the way to go with the 4.6L engine. I would go with an ATI Procharger, I really like that you don't have to put a hole in your oil pan (..cringe..). That is on the pricey side of course.
Gears are a must! expect $400 to $500 for those. Exhaust system: Headers - $200-$300 + install H-pipe - Anywhere from $150 to $375 + install (depending on whether or not you have Cats) Cat back -~$300+ and then add installation. Pulleys will set you back $80+ K&N - ~$50 That's just a start. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
loss of power suddenly | jimdrechsler | Windsor Power | 17 | 09-30-2004 08:49 PM |
power for 500 hp daily | Torinalth | Power Adders | 22 | 09-25-2003 11:54 PM |
Power for the Power Amp | traderguy | Audio, Security, & Electronics | 2 | 07-13-2003 08:07 PM |
power shift? | JamGtStang | Windsor Power | 6 | 03-01-2001 02:11 PM |
Electrical power, where to splice? | Chris_H | Windsor Power | 3 | 02-11-2001 08:29 PM |