![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Jun 2002
Location: Western,MA
Posts: 254
|
![]() hey all
my axle is making a slight clunking sound when i take off so i changed the fluid and took a look inside the diff gave it the once over and everything is fine runout is good backlash is within specs so i checked my u-joints they are fine to, the slip yoke is firm yet when i turn the shaft manualy when it`s on the lift i have about 3/16 play before the gears feel like they engage what else could it be if i have to i`ll put new gears in. could it be the dam c clips making all the noise ![]()
__________________
Rice Haters Club Member #55 For My car Specs Click the Home page link http://www.badassyellowgt.50g.com/ |
![]() |
![]() |
![]() |
#2 |
Registered Member
Join Date: Jan 2002
Location: Texas
Posts: 330
|
![]() Mine does the same thing if I have to slow down quikly.. I have been told is cause by slack in the gear set and it is actually the pinion and ring teeth striking each other because there's a small gap between them.... I don't know if this is the same in your case, but a rear-end shop should be able to answer that for you, other than being an obnoxious noise, I don't know if it would be damaging to the set... I would think after years of it, it may weaken some of the teeth, but I am not a mechanic...
__________________
// 1998 GT-Steeda Conversion \\ -- Sold // Now own 2001 F-150 SuperCrew 5.4L \\ |
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
![]() My rearend has "clunked" a little since the car was new, but only at very slow speeds (1-2 mph) when turning into or backing out of the drive way, which has a very small curb to go over (the slight curb is what causes the clunk), especially when turning sharply when going backward. My '89 5.0 had clunked a little also, so I just figure it's something genetic in the Stang line. Doesn't really bother me though. I never clunk going forward over a smooth surface. Anyways, sounds like you've got something going different, just thought I'd add my two clunking cents. By the way, my driveway clunking go much louder when I added lower control arms.
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
need advice on axle noise | taurus3298 | Windsor Power | 1 | 10-09-2002 08:57 PM |
3.55:1 rear end noise, is it normal? | Mo65 | Classic Mustangs | 16 | 08-26-2002 08:07 AM |
Motor back together - strange noise???? | DZEE'S LX | Windsor Power | 13 | 03-15-2002 12:46 AM |
weird grinding noise from axle | redrider | Windsor Power | 5 | 06-11-2001 08:47 PM |
Air Intake Whistling Noise?! | sgrn | Modular Madness | 4 | 10-25-2000 09:46 AM |