© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-12-2003, 11:07 AM | #1 |
Registered Member
Join Date: Feb 2003
Location: Sarasota,FL
Posts: 10
|
Launch Methods
I am going to run my car tomorrow and I would like to know what you think the best way to launch my car is. I dont want to spin the tires b/c i will lose time that way. What RPM's should start off at and should i dump the clutch. Any help is greatly appreciated.
|
03-12-2003, 04:25 PM | #2 |
Registered Member
Join Date: Dec 2002
Location: Philadelphia PA
Posts: 143
|
Well, you need to give some more information. Is it standard or automatic? What kind of power are you pushing, if you have had it dynod, or what mods have you done to it? What kind of tires are you going run? Nobody can help you if you dont give us something mre than just a question.
__________________
2000 GT 80mm Pro-M mass air, 24lb injectors, 75mm BBK T/B, K&N Filter Cold Air, 1/2" Phenolic intake spacer, Underdrive Pulleys, Dyno Tuned Autologic Chip, FMS Shorty Headers, Mac Prochamber 2 1/2" Off Road H pipe, 2 Chamber Flowmasters, Steeda lowering springs. Steeda Tri-Ax Short Throw shifter, Steeda Power slot rotors w/ Hawk Pro pads, 3.73 FRP Gears. Headwork and Comp cams install in progress. |
03-12-2003, 04:49 PM | #3 | |
Registered Member
Join Date: Apr 2002
Location: racine ,wi
Posts: 691
|
Re: Launch Methods
Quote:
__________________
RUN IT STAIGHT AND RUN IT HARD ________ Novi 2000 60' 1.46 1/4 10.67 mph 126.5 _________ |
|
03-12-2003, 04:51 PM | #4 |
Registered Member
Join Date: Feb 2003
Location: Sarasota,FL
Posts: 10
|
I have Kumho 712 supras on the car, i have 2 1/2 in flowmaster exhaust with an offroad h-pipe, i also have mac underdrive pullies, mac cold air intake and a jet superchip. My car is stock 215 and i dont know what i am running now. And i have never dynoed it either, i also have a 5 speed. Thanx
|
03-12-2003, 05:15 PM | #5 |
Registered Member
Join Date: Apr 2002
Location: racine ,wi
Posts: 691
|
I am not best at getting off the line as you can see in my sig but I got my best times leaving at 3000 and feathering the clutch with a little tire spin any lower it bogged I would have tried higher but ran out of time it seems to take rpms to get the mod motors to get up with the stock gears a lot of guys I have talked to got there best times leaving at 3500-4000 feathering the clutch (i did on stock goodyears)
__________________
RUN IT STAIGHT AND RUN IT HARD ________ Novi 2000 60' 1.46 1/4 10.67 mph 126.5 _________ |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Launch Lesson Please & 60' Times | SleeperGT | Stang Stories | 13 | 03-16-2003 05:01 PM |
Launch Rpm Vs. Stall Speed | ciara | Windsor Power | 2 | 02-16-2003 10:20 AM |
Best Way To Launch On The Street? | steedamustang01 | Modular Madness | 4 | 05-06-2002 10:14 AM |
How to get a good launch? | mustangLX92 | Windsor Power | 8 | 07-27-2001 04:44 PM |
car looks like 4x4 after drag launch springs | WADS56 | Blue Oval Lounge | 6 | 05-13-2001 02:04 AM |