© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-22-2003, 06:49 PM | #1 |
Registered Member
Join Date: Mar 2003
Posts: 3
|
Fuel Filter replacement?? 98GT Quick Help!
HI Gang,
I was hoping to get some quick help on replacing the fuel filter on my 98 GT. Found it..unpluged the shut off switch in the trunk and ran the car out of gas. have it out of the bracket, But I'll be damn if I can get it off...Do you need a tool to release it? Can something else work if so? Thanks |
03-22-2003, 06:55 PM | #2 |
13.3 @ 103
Join Date: May 2001
Location: Maryland
Posts: 253
|
Yes you need a fuel line lock release tool...available at any parts store...get the one with two sizes, one size on each end.
__________________
Equipment by: Steeda C&L COMP CAMS FRPP MSD Bassani Magnaflow MAC Last edited by Red Mustang Gt 46; 03-22-2003 at 07:01 PM.. |
03-22-2003, 06:57 PM | #3 |
13.3 @ 103
Join Date: May 2001
Location: Maryland
Posts: 253
|
When you use it, place it in the fitting until you hear a click, it will come right out...
__________________
Equipment by: Steeda C&L COMP CAMS FRPP MSD Bassani Magnaflow MAC |
03-22-2003, 06:58 PM | #4 |
Registered Member
Join Date: Mar 2003
Posts: 3
|
Thanks Red!!
You rock!! I just sent you Personal message...THANKS!!
|
03-22-2003, 07:06 PM | #5 |
13.3 @ 103
Join Date: May 2001
Location: Maryland
Posts: 253
|
When you get it all together, pressurize the fuel system by turning the key to the on position and wait for a couple seconds before you start the car, this will activate the fuel pump and pressurize the system. It should start right up...
Check for leaks... Have fun...
__________________
Equipment by: Steeda C&L COMP CAMS FRPP MSD Bassani Magnaflow MAC |
03-24-2003, 10:20 AM | #6 |
Registered Member
Join Date: Dec 2002
Posts: 93
|
Can either of you tell me who makes this tool and, if possible, the part number for the tool?
Thanks,
__________________
Greg 98 Mustang GT Coupe |
03-24-2003, 10:35 AM | #7 |
Registered Member
Join Date: Mar 2003
Posts: 3
|
Fuel Line Tool
Hey Greg..
I purchased mine at Autozone. It's made by "OEM" and the part # is 25043. It works like a charm, It has Ford on one end and GM on the other. However, Make sure you get Motorcraft filter if you can..I was in a rush and could not find one at the places I was looking. Mistake! the filter that I installed was from Autozone and the necks or the lines coming off the filter are not as long as the original and the fuel tool will not fit between the filter and the fuel line. SO, the next time I replace it I'm going to have to cut it off Don't make my mistake Good luck Greg Phil |
03-24-2003, 01:03 PM | #8 |
Registered Member
Join Date: Dec 2002
Posts: 93
|
Thanks a lot, Phil...I got the NAPA filter (made by WIX) and I'll compare it to the stock one to make sure they're the same. If not, I'll make a trip to the dealer...
Thanks again,
__________________
Greg 98 Mustang GT Coupe |
03-24-2003, 01:42 PM | #9 |
13.3 @ 103
Join Date: May 2001
Location: Maryland
Posts: 253
|
Glad things went halfway O.K.
The fuel filter for 98 and up Stangs isn't a normal stocking part in some stores yet, so you may have to ask for it at the counter where they stash uncommon parts. I use the Purolator #65277 usually $7-9 bucks.
__________________
Equipment by: Steeda C&L COMP CAMS FRPP MSD Bassani Magnaflow MAC |
03-24-2003, 01:53 PM | #10 |
Registered Member
Join Date: Dec 2002
Posts: 93
|
Another question for you guys...if you use the right tool to release the fuel line clips, can you re-use them when installing the new filter? The plastic clips that came with my new filter look kinda chintzy...
Thanks,
__________________
Greg 98 Mustang GT Coupe |
03-24-2003, 01:59 PM | #11 |
13.3 @ 103
Join Date: May 2001
Location: Maryland
Posts: 253
|
CADreamin...you should not have any clips, the 98 and up filter locks in the fuel line fitting itself. Double check the part you bought, the 79-97 Stangs use clips to hold the fuel line in place...
__________________
Equipment by: Steeda C&L COMP CAMS FRPP MSD Bassani Magnaflow MAC |
03-24-2003, 02:13 PM | #12 |
Registered Member
Join Date: Dec 2002
Posts: 93
|
Oh...OK, thanks. I'm glad I ask about these things before tearing right in...
__________________
Greg 98 Mustang GT Coupe |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
dumb question- fuel filter? help | Crazy Horse GT | Modular Madness | 9 | 09-04-2002 04:40 PM |
fuel filter | 1jimmy__d | Windsor Power | 4 | 08-21-2002 06:17 AM |
89 LX Fuel Problems | Ryan94GT | Small Ponies | 0 | 08-19-2002 09:47 PM |
quick fuel system question | clearwaterms | Windsor Power | 9 | 04-06-2001 12:19 PM |
Smelling Fuel.....Damn Fuel Regulator | Piston | Windsor Power | 3 | 03-23-2001 01:35 AM |