Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-11-2005, 05:20 PM
|
#4 |
|
Registered Member
Join Date: Feb 2002
Location: Maryville,TN
Posts: 415
|
Re: Pi Intake Problems!!
The tabs you were talking about should fit if you are using the NPI gaskets. If not cut the out, they are there to hold it in place, enogh gasket sealer will do the same thing. You also need to replace the coolant tube that is in the valley under the intake as well as the water pump nipple. You can use a piece oof heater hose and a few clamps and accomplish the same thing but the correct hose and nipple looks better and may last longer. The switch is easy and can be done in a few hours. One of the best bangs for the buck. Mine cost me a total of $110.00 bucks and took less then 3 hours for a total of 20rwhp!
God luck! 
__________________
98 GT / convertable -98 Saleen engine, Saleen appearance pkg. SHM cams,P&P NPI heads, and so much more! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New Intake with NITROUS!!!???? | NOSstang08690 | Power Adders | 9 | 09-09-2003 07:05 AM |
| Head and intake flow. Something to think about. :) | 5ohCOUPE | Windsor Power | 3 | 03-16-2003 08:52 AM |
| 4.6L Intake spacer!!!! | skz4u | Modular Madness | 18 | 01-27-2003 11:11 PM |
| Edelbrock spec's and intake question?? | jerryIII | Windsor Power | 0 | 05-24-2001 12:49 PM |
| FYI-4.6 intake problems | PKRWUD | Modular Madness | 6 | 02-01-2000 02:26 PM |