Kiss another T-45 bye!

Cracker · 06-04-2000, 08:47 AM

Just broke my T45 the other night. It is under warranty, so it will be replaced by the dealer, but I am begining to think I would rather go with a Tremec. Can anyone offer any information on what I would need to do this?
Also, what would it cost for parts? Any information is appreciated.

paver one · 06-06-2000, 02:08 PM

New TREMEC 3550 will run you about a thousand, shifter $200 and bell housing another $250....Add another $100 to get your drive shaft shortened and rebalanced.......While your there take a good look at the clutch and throw out bearing,,,,replace if there is any doubt....Also check the flywheel for grooves and have it trued if necessary or go to an aluminum flywheel.....

------------------

06-04-2000, 08:47 AM	#1
Cracker Registered Member Join Date: Jul 1999 Location: Dearborn, MI Posts: 53	Kiss another T-45 bye! Just broke my T45 the other night. It is under warranty, so it will be replaced by the dealer, but I am begining to think I would rather go with a Tremec. Can anyone offer any information on what I would need to do this? Also, what would it cost for parts? Any information is appreciated.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
All time Favorite song?	Coupe Devil	Blue Oval Lounge	41	12-23-2001 10:42 AM
Where was your first kiss?	StangLady	Blue Oval Lounge	20	01-24-2001 12:12 AM

06-06-2000, 02:08 PM	#2
paver one Registered Member Join Date: Jan 2000 Location: Ogden Utah Posts: 58	New TREMEC 3550 will run you about a thousand, shifter $200 and bell housing another $250....Add another $100 to get your drive shaft shortened and rebalanced.......While your there take a good look at the clutch and throw out bearing,,,,replace if there is any doubt....Also check the flywheel for grooves and have it trued if necessary or go to an aluminum flywheel..... ------------------