![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Jan 2000
Location: Warner Robins, GA, USA
Posts: 210
|
![]() I have a 2.5" off-road H-pipe laying around and am thinking of purchasing a couple of high flow cats and welding them in this H-pipe to replace my factory 2.25" pipe on my Cobra. Does this sound reasonable? I can get 2 hi-flow cats for around $150. It will be a good bit cheaper than buying a new H-pipe with cats. My biggest concern is placement - I think the converters have to go in between the O2 sensors, is this right? And also, will using only one cat per side set the check engine light? I'm not sure how the EEC uses the signals from the 4 oxygen sensors, maybe someone out there in the know can shed some light on it.
------------------ '97 Cobra, K&N, 3.73s, Rio Red |
![]() |
![]() |
![]() |
#2 |
Registered Member
Join Date: Oct 1999
Location: Cincinnati, Ohio
Posts: 1,575
|
![]() Just stick with the off road h-pipe unless you have emissions, it really makes the car sound alot better and you gain some serious HP on the top end with that high revving motor.
------------------ 87 GT, 4 inch cowl hood, long tubes headers,h-pipe,Flows,BBK cold air, Mass air,70mm MAF, 1.7's, 1" spacer,underdrive pulleys,Pro 5.0, King Cobra, Adj. fuel Reg., Lakewood Lift Bars,50/50's,subframes, 4.10's. Best time 13.012 Best MPH 104 Best 60' 1.816 Also a 40' Ford Coupe Legend Race car #16. 1200cc Yamaha, oil cooler, fans. Visit my site at: http://www.geocities.com/cobrar93_2000/MyPage.html |
![]() |
![]() |
![]() |
#3 |
Registered Member
Join Date: Jul 2000
Location: Baltimore, MD
Posts: 516
|
![]() Or if you're set on the cats, sell that H pipe and get the entire Hi Flow BBK system. You will rest easy, less work, and only end up spending about $75- $100 more (considering you get a reasonable price for the old one) for an entire new system without all the welding work and worrying about the engine light. I have heard BBK's hi flow system. I think it sounds as good as it gets if you have to use cats.
------------------ 1997 Cobra, C+L 80mm MAF, Pro 5.0 shifter, BBK Springs, Taylor Wires, 2 Chamber Flows, 3.73's |
![]() |
![]() |
![]() |
#4 |
Registered Member
Join Date: Jan 2000
Location: Warner Robins, GA, USA
Posts: 210
|
![]() Will the BBK cat H-pipe set the check engine light or will I need MIL eliminators?
------------------ '97 Cobra, K&N, 3.73s, Rio Red |
![]() |
![]() |
![]() |
#5 |
Registered Member
Join Date: Aug 2000
Location: Torrington, CT, USA
Posts: 145
|
![]() No MIL elimators needed with any Cat H-Pipe...
------------------ 2000 GT Conv. 5speed Triple Black Current Mods: K&N, Mobile 1, MagnaPack Cat-Back, Steeda Tri-Ax ET: 14.32@100.0 Upcoming Mods: BBK Longtubes, BBK H-pipe w/cats, and much much more |
![]() |
![]() |
![]() |
#6 |
Guest
Posts: n/a
|
![]() i've tried the offroad h pipe and it does sound good but the bassani Xpipe w/cats made more power and torque but was quieter. i think the 4.6 needs a little more backpressure than the 5.0
------------------ (96Cobra/softtop-3.73,almdrvsht,fancontrl,steeda sbfrmes+shifter,eibachspgs,pulleys,Bassani X pipe,C&L 80mm Cobra DYNO 301rwhp horsepower w/out steeda timing adjuster 93 Ford Probe Gt(slower but turns) |
![]() |
![]() |
#7 |
Registered Member
Join Date: Jan 2000
Location: Warner Robins, GA, USA
Posts: 210
|
![]() Right now I am leaning towards an H-pipe, simply because I have heard it adds a little more torque than an X-pipe, and my 4.6 4V could use a little more low end. Also is it true that the X-pipe has a higher pitch than an H-pipe?
------------------ '97 Cobra, K&N, 3.73s, Rio Red |
![]() |
![]() |
![]() |
#8 |
Guest
Posts: n/a
|
![]() trust me bro, the X pipe makes more torque from my experience. on the 4 valve, this is the way to go.
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
hi flow cats street legal? | chuck88 | Windsor Power | 4 | 12-29-2002 07:50 AM |
Hi flow cats X/H pipe??? | chuck88 | Windsor Power | 3 | 12-04-2002 07:06 PM |
High flow cats and CA emmisions | The Deuce | Modular Madness | 2 | 08-23-2002 12:29 PM |
High flow cats | hawaii5_0 | Windsor Power | 4 | 05-06-2002 12:48 AM |
Hi flow cats | FASTFRANK | Windsor Power | 1 | 02-27-2002 08:42 PM |