© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-26-2001, 12:08 AM | #1 |
Registered Member
Join Date: Aug 2001
Location: Glen burnie, MD. 21060
Posts: 2
|
Starting/Stalling Problems
I can go for days without a problem, then my mustang will startup and 15 seconds later will stall out and won't start for 15-45 minutes, then out of no where will fire right up and drive for 5-10 minutes then stall again and repeat the same process where I can go for days without a problem, once the car stalls it will crank over with plenty of power but the engine just won't fire.
|
08-26-2001, 08:52 AM | #2 |
Registered Member
Join Date: Dec 1998
Location: Manhattan, KS 66502
Posts: 599
|
Try replacing the fuel filter first. It's cheap and a good place to start. Sometimes if there's an obstruction it can block fuel flow and then drift back down the fuel line causing the "starts sometimes/ stalls" scenerio.
Just a thought. Brett ------------------ 66 Tahoe Turquoise Coupe Laser Red 96GT Ragtop 30 Years & 30 inches apart in the driveway! |
08-26-2001, 12:29 PM | #3 |
Registered Member
Join Date: Jan 1999
Location: Danbury, CT, USA
Posts: 273
|
I posted a similar topic about a month ago without getting many replies. My car would struggle starting up in the mornings (it seemed that way). One morning it took about 20 tries before starting. I took it to the dealer. They said it was a loose ground wire from the fuel pump. Okay, go to pick up the car and it won't start (afternoon now, I'm surprised). Walk into the service dept and tell them the car won't start. Hmmm, very puzzling. It turns out the car wasn't getting any fuel due to the throttle valve assembly(?) being jammed closed. It was replaced and the car fired right up. The tech who worked on the car said they've had trouble with this part recently.
------------------ ************************ 1999 GT - Laser Red K&N, Steeda pulleys, Steeda strut tower brace & Tri-ax (Upcoming mods: subframes (bought), Bassani X (next), & FMS 3.73s [This message has been edited by Ripper (edited 08-26-2001).] |
08-26-2001, 02:47 PM | #4 |
Registered Member
Join Date: Aug 2001
Location: Madison, MS
Posts: 52
|
The idle air control valve on my 96 Cobra gets stuck all the time especially when it is very humid outside. It will crank but idles very low and will die if you give it gas then let off. Strangly enough all it takes to unstick it is to pop it with a screw driver. Just my $.02!
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
what if any problems with your Modular Model Gt/Cobra? | fixer | Modular Madness | 18 | 04-03-2005 09:18 AM |
HELP: Problems after Paxton Novi 1000 install | Meatman | Windsor Power | 3 | 10-17-2002 06:03 PM |
Sick 88 Gt Computer problems? | ziggy_2k | Windsor Power | 5 | 06-02-2002 10:33 PM |
'65 - Pull Away Problems - Action Plan | geordie | Classic Mustangs | 0 | 05-14-2002 01:43 PM |
Cooling System problems | 1973Mach1 | Classic Mustangs | 7 | 06-25-1999 10:33 PM |