Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-10-2002, 08:27 PM
|
#1 |
|
Registered Member
Join Date: Jun 2002
Location: Belen, New Mexico
Posts: 1
|
Bullit Intake Aftercooled Discharge Tube
After being misinformed, I ordered a bullit intake for my 00GT which already has an S-trim and GT aftercooler. I was told a Cobra discharge tube for the aftercooler kit would work. Vortech says I have to order another cooler ($925 bucks). The discharge tube is oval on both ends and my GT cooler has a round end. Anyone have this same problem before and please any suggestions on fabricating a discharge tube?
Thanks, SlwGT
__________________
00GT S-trim Aftercooled 12#'s J & E Pistons, Manley Rods, Crane regrind cams Mac Long Tubes, Pro-Chamber, Mac Cat-back, 3.73 |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bullit Intake. How does it flow? | Mercury | Blue Oval Lounge | 15 | 05-30-2001 08:59 PM |
| Edelbrock spec's and intake question?? | jerryIII | Windsor Power | 0 | 05-24-2001 12:49 PM |
| OIL IN INTAKE almost sure from 'pcv' | QUIN | Windsor Power | 8 | 03-09-2001 01:58 PM |
| New MAC intake? | gt93mustang | Windsor Power | 19 | 01-22-2001 03:33 PM |
| does gt40 intake work with sn95? | daz95gt | Windsor Power | 8 | 01-13-2001 08:20 AM |