Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-28-2004, 04:41 PM
|
#1 |
|
Registered Member
Join Date: May 2004
Location: Lancaster, PA
Posts: 1
|
New At This
I was wondering if I could buy stuff made for GTs or Cobras to install into my V6 mustang? And if so, how much modification would I need to do to my car?
I'm really new at this, and it's really hard for me to find stuff for my 2000 Mustang V6.. Any advice would be appreciated.. To contact me: e-mail: dcampoy@comcast.net |
|
|
|
07-29-2004, 02:05 PM
|
#2 | |
|
Registered Member
Join Date: Apr 2002
Location: racine ,wi
Posts: 691
|
Re: New At This
Quote:
a lot of the companys that make bolt on parts for the v8 make bolt ons for the v6 as well
__________________
RUN IT STAIGHT AND RUN IT HARD ________ Novi 2000 60' 1.46 1/4 10.67 mph 126.5 _________ |
|
|
|
|
|
08-02-2004, 02:06 PM
|
#3 |
|
Mustang Addict
Join Date: Jan 2001
Location: McKinney, TX
Posts: 1,294
|
You can bolt on suspension and brake parts made for a non-IRS stang, but all the drivetrain stuff is different.
__________________
Strike down the unroadworthy! 2000 GT Atl. Blue: '03 Cobra motor - 465rwhp/473rwtq, T-56 6-speed, full MM TA/PH & tubular K-member suspension, Saleen body, 17" Torq-Thrust II's, M/T ET Street radials, and lots more '94 Rio Red Cobra: All the bolt-ons, 3.73s |
|
|
|
 |
|
|