Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-24-2003, 10:29 PM
|
#1 |
|
Registered Member
Join Date: Jul 2003
Posts: 2
|
fuel lines
I just bought a Vortech V2-SQ from Steeda and I have to send them my fuel pump and ECU, but I can't get the fuel line off the pump assembly. I have the tool, but I can't get it to engage and remove the line. Any suggestions or I am I just not getting it off!
|
|
|
|
07-26-2003, 06:28 AM
|
#2 |
|
13.3 @ 103
Join Date: May 2001
Location: Maryland
Posts: 253
|
I'm sure youv'e probably already tried this but... before you insert the tool (I assume the "duck bill" type), press the fuel line into the fitting and then insert the tool until you hear a click, this relieves any pressure between the fitting and fuel line...you can also turn the tool on a clock wise motoin to make sure the fitting dis-engages on all contact points.
Also, are you using the right size line lock release tool, 3/8 or 5/16th?
__________________
Equipment by: Steeda C&L COMP CAMS FRPP MSD Bassani Magnaflow MAC   
|
|
|
|
|
07-26-2003, 04:48 PM
|
#3 |
|
Registered Member
Join Date: Jul 2003
Posts: 2
|
thanks, I ended up getting it off. It was just being a pain in the butt!
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Will fuel boil if lines are too close to headers? | Stang_ROTY | Windsor Power | 16 | 07-12-2003 11:12 AM |
| Fuel lines | WhiteLX | Windsor Power | 8 | 08-17-2002 07:32 AM |
| Fuel Lines...EMERGENCY HELP!! | quick89gt | Windsor Power | 1 | 03-20-2001 06:08 PM |
| FUEL LINES: Help please! | quick89gt | Windsor Power | 3 | 03-17-2001 12:53 PM |
| EFI fuel lines and spark plugs | vangogh | Windsor Power | 0 | 02-20-2001 02:40 PM |