© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-12-2002, 12:02 AM | #1 |
Registered Member
Join Date: Sep 2001
Location: Auburn,GA
Posts: 25
|
Exhaust leak. Please Help!!
I just installed my Mac prochamber and it sounds like it is leaking at the headers. Can't seem to get it tight enough. Any suggestions? Would it be ok if I drove it up to the Mustang shop down the road to have them look at it? Don't want to mess anything up driving around with it leaking like that. Thanks a lot!!
__________________
2000 GT, MAC 2.5" Cat-Back, MAC Prochamber, MAC cold air. 3.73's and pullies are next!!! |
01-12-2002, 11:25 AM | #2 |
Git jiggy
Join Date: Oct 1999
Location: MO USA
Posts: 865
|
It's not going to hurt it driving it up to the shop. Do you have everything lined up correctly so that you CAN tighten it down? You might take it apart and recheck everything before you go spending money to have someone else do it. Might try an impact wrench if nothing else.
__________________
1967 Mustang Coupe |
01-12-2002, 03:24 PM | #3 |
Registered Member
Join Date: Oct 2000
Location: Saxonburg, PA, USA
Posts: 236
|
No it wont hurt the car. I would put money its the passenger side connection at the manifold thats leaking. I had trouble keeping the bolts tight with my X-pipe and ended up having to use loctite on the nuts. Also make sure you used the gasket on that side. Now my only leak is a pin hole where I missed a spot when welding cats on x-pipe.
__________________
Ed.. My Mustangs webpage NMRA M/M 7222 2000 Mustang GT - 5 speed Race weight w/o driver 3086lbs, 3250 w/ driver Best 1/4mile run to date: 12.79@105.96, 60' 1.76sec.(10-27-02) Best MPH 106.03(10-27-02)4.10gears |
01-12-2002, 11:46 PM | #4 |
Registered Member
Join Date: Sep 2001
Location: Auburn,GA
Posts: 25
|
I got it now. It was the driver's side. I was thinking passenger side also, but it was ok. There is a spacer on the header bolt that was stopping me from tightening it all the way. It is on tight now. Sounds awesome!
__________________
2000 GT, MAC 2.5" Cat-Back, MAC Prochamber, MAC cold air. 3.73's and pullies are next!!! |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Exhaust leak | StateTroopCoupe | Windsor Power | 1 | 09-25-2003 08:21 AM |
Help!! Exhaust Leak | 1991GT | Windsor Power | 5 | 12-13-2002 09:39 PM |
Speed Secret # 4 | jim_howard_pdx | Windsor Power | 13 | 11-10-2002 03:42 PM |
Header gaskets | Stang951 | Windsor Power | 18 | 11-01-2002 05:57 PM |
Exhaust leak? | oamunoz | Classic Mustangs | 4 | 07-13-2001 03:00 AM |