Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-11-2000, 11:34 PM
|
#1 |
|
Registered Member
Join Date: Jul 1999
Location: rocky point, NY ,USA
Posts: 65
|
strut tower brace
I just got my steeda strut tower brace on today and it was nothing but problems!We had to modify the MAC cold air kit, move several wireing harnesses,and squeeze it next to the fuse panel on the drivers side and a little panel on the passenger side. It also was very hard to get behind the firewall to bolt down the back.It does seem to stiffen up the front, but needs a patient person to deal with it.The pullies went on much easier,only had to move the coolent overflow out of the way to get at the alternator bolt.
------------------ 1999 GT AOD,FMS 70MM TB,Steeda pullies,Dynomax Super Turbos,MAC cold air kit,Steeda strut tower brace,ATS-III seq. turn signals |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Strut Tower Brace | saleen243 | Windsor Power | 1 | 02-18-2003 04:52 PM |
| Will a 94GT Strut Tower Brace fit on a 99+ GT | NYC1 | Windsor Power | 0 | 12-27-2002 01:20 PM |
| Help! Strut Tower Brace - Will it fit w/this intake? | daveGT | Windsor Power | 5 | 08-05-2002 04:24 PM |
| caster/camber plates used with a strut tower brace | jtl | Windsor Power | 1 | 02-10-2002 10:31 PM |
| Strut tower brace install? | Ripper | Modular Madness | 1 | 03-28-2000 10:47 AM |