© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-16-2006, 06:51 PM | #1 |
96GREENGT
Join Date: Mar 2005
Location: las vegas
Posts: 51
|
vibration at 3k
just got a centerforce dual friction clutch kit installed. at same time, swapped to a new centerforce throw-out bearing, and a new pilot bearing supplied by the shop were i had install done. problem is, at 3,000 RPM in any gear, there is a bad vibration that rattles the whole car. wasn't there prior to clutch swap, even after swap to 3.73 gears. i still have 200 miles or so to go on the 450-500 mile break-in period recommended by centerforce on clutch. when the rattle comes on, the car seems to lose some steam. will this clear up after 200 or so miles, once the clutch is broken in and set correctly? i have been going fairly easy on the gas during the break-in (no WOT).
__________________
-'96 GTS Deep Forest Green Metallic- 8#Powerdyne,Bassani Cat-X,2 chamber Flows, FMS alum. DS,Kenne Brown subframes,Pro 5.0 short throw,FRPP 3.73's,Accufab Plenum/75mm TB,11# blower pulley,Bassani mid headers,Eibach 1.5" springs,17" Cobra R's w/ 275/40zr-17 g-force kd's,Centerforce Dual Friction -'87 Black LX 5.0 BBK shorties&Cat-X,2 chamber Flows,MSD ign,stock 3.08's,MGW short-throw,BBK cold-air,King Cobra clutch,235/55-17(F)&255/50-17(R) Kumho Ecsta's on 95 Cobra R 4-lugs |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
follow up to horrible vibration problem | Toeclicker | Windsor Power | 4 | 12-18-2003 06:38 PM |
rear end vibration | stang_guy_95 | Windsor Power | 4 | 12-17-2003 04:53 PM |
Vibration Problem | RDMumfts Stang | Windsor Power | 10 | 03-23-2003 07:04 PM |
Something bad is about to happen to my car - vibration from somewhere | 2FastLX | Windsor Power | 6 | 08-20-2001 09:27 AM |
Vibration thru vehicle when accelerator is pressed | race1now | Windsor Power | 1 | 01-22-2001 12:28 AM |