Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-09-2003, 07:35 AM
|
#1 |
|
Registered Member
Join Date: Mar 2003
Posts: 32
|
86gt Alignment
Installed Ford Racing caster camber plates on my 86gt with sn95 spindles, cant get +3 degrees caster. It will only go to +1.8 with -.7 camber. We can get -1 camber but it drops the caster lower because of the strut opening being round. Steeda says that I wont be able to get anymore caster because of it being an 86 or earlier. Anybody have any ideas? Maximum Motorsports says to notch the top of the strut towers which is fine but seems like there should be enough adjustment with out doing this. Everything underneath is centered up and aligned.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 8.8 or 7.5 in 86GT?? | Comatose | Windsor Power | 9 | 06-09-2004 10:08 PM |
| Front End Alignment | orlowted | Classic Mustangs | 5 | 03-26-2004 08:38 AM |
| 88-91 CV Chassis Alignment Specs | door64 | Blue Oval Lounge | 0 | 03-23-2002 06:36 AM |
| Alignment Problems...... | Her99GT | Modular Madness | 7 | 01-30-2002 08:23 AM |
| Do I need to use pressure plate alignment dowels with clutch install? | TROYXTROY | Windsor Power | 4 | 01-25-2001 02:12 PM |