Brake Problems

[ddawson]

My left brake caliper is getting no brake fluid. When braking only the right
side works.

I pulled the brake line from the caliper and only drips come out when the
pedal is pumped.

Here is what I have so far. I gutted the proportion valve and installed the
FMS plug. On the kit I have from MPS it uses some of the same parts as the
Cobra kit. I unscrewed the pack portion of the prop valve and installed the
new connector which feeds the left front brakes.

The question I have is should I have taken anything out of the rear prop
valve? The Cobra instruction only mention gutting the front.

I'm going to take it all apart again to see if there is something in there
block flow but I though I would ask before doing the work.

Dan Dawson
Bay Area, California
88 5.0 LX, Red, Special Order, No Options,
Vortech A-Trim Supercharger, 9 PSI, PowerFlex Pipe, MAX Flow 73mm MAF,
Global West LCA's, Global West Springs 800/190, Koni Yellows, MSD Coil,
Hurst Shifter, Tri-Ax Handle, 190 Fuel Pump, 3.55 Gears,
Maximum Motorsports Full Length Subs and Caster/Camber Plates,
Five Lug Conversion, SVO Calibers, 96 Cobra Rims, Nitto 555's 255/45-17,
Work in Progress, SN95 Rear Disks.