G-load brace
I'm planning on buying or making a G-load brace, but from the pictures in the ad I can't figure out where it bolts to. All the ads say, "no drilling, just bolt on and go".
I know they attatch the k-member to the unibody, but I can't see where there are pre-existing holes. Any help is appreciated. ------------------ 90LX Ragtop. K&N, 2.25'' Flowmasters, Hollow cats, Crank pulley, Crane 2031, Crane rockers, Holley FPR. Need Gears Bad!!! |
Here is a picture of the g-load brace
http://www.mustangworks.com/~drudis/.../underside.jpg ------------------ Darius Rudis Roadracer: Home built t-arm/panhard suspension powered by an S-trimmed motor :-) My Mustang Page [This message has been edited by Dan McClain (edited 10-18-2000).] |
Kewlbeans, I see how it attatches to the K-member. I'll have to fab my own so they can clear a set of long tube headers
|
All times are GMT -5. The time now is 04:20 PM. |