MustangWorks.com : Ford Forums - View Single Post - G-load brace

jeb · 10-17-2000, 03:38 PM

I'm planning on buying or making a G-load brace, but from the pictures in the ad I can't figure out where it bolts to. All the ads say, "no drilling, just bolt on and go".
I know they attatch the k-member to the unibody, but I can't see where there are pre-existing holes.
Any help is appreciated.

------------------
90LX Ragtop. K&N, 2.25'' Flowmasters, Hollow cats, Crank pulley, Crane 2031, Crane rockers, Holley FPR.
Need Gears Bad!!!

10-17-2000, 03:38 PM	#1
jeb Registered Member Join Date: Sep 1999 Location: Deltona Fl Posts: 140	G-load brace I'm planning on buying or making a G-load brace, but from the pictures in the ad I can't figure out where it bolts to. All the ads say, "no drilling, just bolt on and go". I know they attatch the k-member to the unibody, but I can't see where there are pre-existing holes. Any help is appreciated. ------------------ 90LX Ragtop. K&N, 2.25'' Flowmasters, Hollow cats, Crank pulley, Crane 2031, Crane rockers, Holley FPR. Need Gears Bad!!!