Front suspension beef-up
 

I'm not sure if this is the right place to post this, but I'm re-doing my front suspension and wanted some suggestions. I want a tubular K member and coil over springs. Now...this car will be a fair weather/weekend warrior car but I might also show it so this stuff has to ride as well as it works. This will also be dropped in along with a new motor, transmission, rear end, and a torque arm/panhard bar setup. Can anyone give me any suggestions?

------------------
1984 1/2 GT350 (#842 Hatchback w/ T-tops), 302HO, Comp cams Xtreme Energy cam, Carter 625cfm carb, Weiand Stealth intake, MSD distributor, MSD coil, FMS 9mm wires, 1 5/8" MAC unequal shorties, 2 1/2" MAC Prochamber H-pipe, Flowmaster 2 chambers, KYBs, 16"x8" 4 lug Cobra Rs, Falken 245/45ZR16s

Griggs is always good. Its not cheap, but you deffently get what you pay for.
http://www.griggsracing.com/

Maximum Motorsports is also coming out with a K-member at some point. They're another good quality company and a bit cheaper then Griggs.
http://www.maximummotorsports.com/

Call www.griggsracing.com and hide the VISA bill http://www.mustangworks.com/msgboard/wink.gif
Take a look at my homepage. I just completed the front setup (need to post newer photos) but finally have the whole ehchalada...


------------------
Darius Rudis
Roadracer: Home built t-arm/panhard suspension powered by an S-trimmed motor :-)
My Mustang Page

I had to hide the Discover bill also! http://www.mustangworks.com/msgboard/wink.gif

Hey drudis-

That stuff looks pretty sweet. What parts exactly did you get from them? I've seen their website before a looooong time ago and the stuff wasn't insanely expensive (a little pricey, but didn't seem too bad). That looks like a bad @ss setup.

------------------
1984 1/2 GT350 (#842 Hatchback w/ T-tops), 302HO, Comp cams Xtreme Energy cam, Carter 625cfm carb, Weiand Stealth intake, MSD distributor, MSD coil, FMS 9mm wires, 1 5/8" MAC unequal shorties, 2 1/2" MAC Prochamber H-pipe, Flowmaster 2 chambers, KYBs, 16"x8" 4 lug Cobra Rs, Falken 245/45ZR16s

I bought THIS
http://members.mustangworks.com/drud...s/griggs02.jpg

See my homepage for LOTS more photos of the install.

------------------
Darius Rudis
Roadracer: Home built t-arm/panhard suspension powered by an S-trimmed motor :-)
My Mustang Page