Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-10-2003, 12:26 PM
|
#1 |
|
Registered Member
Join Date: Mar 2003
Posts: 32
|
Roll cage questions
I run in c-prepared at my local SCCA club and i'm getting ready to install a roll cage in my 86gt. Rules say that its not required for this class but if done needs to be 1 3/4 x .120 DOM. If its not required anyway could I just use 1 3/4 x .095 ERW since its just used to tie everything together. Price is half of what a DOM cage is.
Marcell |
|
|
|
11-12-2003, 04:41 PM
|
#2 |
|
Moderator
Join Date: Dec 1999
Location: Livonia, MI, USA
Posts: 1,194
|
I would confirm with the rulebook. Or even ask a local inspector and make sure! You get it wrong... DOH!
You may also look into "similar" rulebooks, in case you wish to cross-polinate and try NASA AI/AIX series, or CMC CamaroMustangChallenge...
__________________
Darius Rudis, Moderator Corner Carvers Delight 1989 Mustang LX - Open Track Car http://www.dariusrudis.com |
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 8-point competition engineering roll cage | Dog5ohfun | Windsor Power | 3 | 02-23-2004 01:34 AM |
| Questions on Roll Cages, Welding, and Ignition | BlackFireN2O | Windsor Power | 3 | 08-25-2002 08:01 AM |
| Roll cage install ...a few questions | Fox Body | Racer's Club House | 2 | 07-15-2002 04:41 PM |
| Gathering info on roll cage installation. | Fox Body | Windsor Power | 5 | 02-25-2002 11:35 PM |
| ROLL CAGE vs. NJDMV | RMARIANI | Windsor Power | 8 | 02-09-2001 06:49 AM |