MustangWorks.com : Ford Forums - View Single Post

drudis · 07-02-2001, 03:00 PM

Ok, I was daydreaming about doing a cutom rotor on hat for the 13" Mustang brakes...

Assuming I had CHEAP access to rotors, would it be worthwhile to do a custom hat for the Mustang?

If I were to get a 13" Coleman rotors like this:

then order a Coleman custom hub:

Could I end up with something that I saw on the Griggs Racing suspension website:

------------------
Darius Rudis
Roadracer: Home built t-arm/panhard suspension powered by an S-trimmed motor :-)
My Mustang Page

[This message has been edited by drudis (edited 07-02-2001).]

07-02-2001, 03:00 PM	#5
drudis Moderator Join Date: Dec 1999 Location: Livonia, MI, USA Posts: 1,194	Ok, I was daydreaming about doing a cutom rotor on hat for the 13" Mustang brakes... Assuming I had CHEAP access to rotors, would it be worthwhile to do a custom hat for the Mustang? If I were to get a 13" Coleman rotors like this: then order a Coleman custom hub: Could I end up with something that I saw on the Griggs Racing suspension website: ------------------ Darius Rudis Roadracer: Home built t-arm/panhard suspension powered by an S-trimmed motor :-) My Mustang Page [This message has been edited by drudis (edited 07-02-2001).]