![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Oct 2000
Location: Santa Lucia di Budoia, Italy
Posts: 217
|
![]() Anyone have any ideas where the spacers go if the car is lowered 1 1/2" (BBK's)? These are the Pro3i plates aka hotparts.com aka Maximum Motorsport. Thanks a bunch, Hector
__________________
86 GT T-tops |
![]() |
![]() |
![]() |
#2 |
Moderator
Join Date: Dec 1999
Location: Livonia, MI, USA
Posts: 1,194
|
![]() I put mine "underneath" to give the strut as much travel as possible (before it bottoms out).
Just watch the hood. Put a piece of clay on it, and lower the hood gently to make sure you got the clearance. Mine was ok. ![]()
__________________
Darius Rudis, Moderator Corner Carvers Delight 1989 Mustang LX - Open Track Car http://www.dariusrudis.com |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help woth installing groundpounder coilovers with BBK caster camber plates | ciara | Windsor Power | 0 | 01-10-2004 01:08 PM |
best camber/caster plates | johnmcgt | Windsor Power | 3 | 06-11-2003 08:02 PM |
crank shaft spacers | BilLster | Windsor Power | 0 | 04-24-2003 02:53 PM |
Is anyone using PRO3I C/C plates? | LOCASH | Corner Carvers Delight | 4 | 02-20-2002 03:03 PM |
caster/camber plates used with a strut tower brace | jtl | Windsor Power | 1 | 02-10-2002 10:31 PM |