Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-02-2000, 03:56 PM
|
#1 |
|
Registered Member
Join Date: May 2000
Location: El Cajon, CA
Posts: 77
|
Panhard Bar
I want one for my 95 Cobra. Any suggestions on which one to get. I already have eibach pro kit springs, bilsteins shocks, and MM camber plates. My intent is to lower my roll center and cut down on sway without going stiff springs or big sway bars.
------------------ ------------------ 95 Blown Cobra #83 of 4005 ------------------ |
|
|
|
07-03-2000, 08:36 AM
|
#2 |
|
Moderator
Join Date: Dec 1999
Location: Livonia, MI, USA
Posts: 1,194
|
Caution: DONT use Saleen/Steeda/BBK... panhards. Not heavy duty. Use either the Griggs standard duty (non-adjustable) or their HD (adjustable) or Maximum Motorsport ones.
------------------ Darius Rudis Roadracer: Home built t-arm/panhard suspension powered by an S-trimmed motor :-) My Mustang Page |
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Panhard Bar | Hans 95 Cobra | Corner Carvers Delight | 1 | 12-05-2001 10:37 AM |
| Panhard Bar | Patrick Boetticher | Windsor Power | 1 | 04-14-2001 08:59 PM |
| Saleen Panhard = POS | turbolx | Corner Carvers Delight | 4 | 09-06-2000 09:42 AM |
| Which panhard bar to use? | drudis | Corner Carvers Delight | 4 | 08-01-2000 11:14 AM |
| Torque Arm - Panhard Bar set-up | autoX | Corner Carvers Delight | 4 | 02-25-2000 02:48 PM |