© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-20-2005, 08:02 AM | #1 |
Registered Member
Join Date: Mar 2000
Location: minneapolis, mn
Posts: 158
|
coil overs..
anyone running coil overs? I know MM has a couple kits for this. Im just wondering how they perform and what you guys think of them? I might go this route vs conventional springs and shocks but would like some opinions and thoughts from those that are running them..
Thanks guys.
__________________
1991 LX coupe,AOD, red, 80k, K&N, MAC cat back, MAC off-road X, Autometer Gauges, BBK Ceramic unequals, fully polished upper intake, fuel rails, and egr, working on installing.....MM full length subs, H&R sport springs, MM Lower control arms, MM caster camber plates, bilstein shocks, struts. |
09-21-2005, 03:42 PM | #2 |
Moderator
Join Date: Dec 1999
Location: Livonia, MI, USA
Posts: 1,194
|
Re: coil overs..
Why do you wish to change?
Its MUCH more expensive, yet the adjustability is nice. I run them in the front (only) on my roadracer. Rears, I use the adjustable spring perch on the lower control arms.
__________________
Darius Rudis, Moderator Corner Carvers Delight 1989 Mustang LX - Open Track Car http://www.dariusrudis.com |
09-23-2005, 03:32 PM | #3 |
Mustang Addict
Join Date: Jan 2001
Location: McKinney, TX
Posts: 1,294
|
Re: coil overs..
I run them on the front of my daily driver that occasionally sees open track duty. I like the ride height adjustability and the ease of changing springs if you need two different rates for street and track. Also, they are lighter than stock springs and they improve ride quality for a given spring rate. In the back I run coilover type springs in the stock position with weld-in adapters and adjustable height control arms.
__________________
Strike down the unroadworthy! 2000 GT Atl. Blue: '03 Cobra motor - 465rwhp/473rwtq, T-56 6-speed, full MM TA/PH & tubular K-member suspension, Saleen body, 17" Torq-Thrust II's, M/T ET Street radials, and lots more '94 Rio Red Cobra: All the bolt-ons, 3.73s |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help adjusting coil overs | ciara | Windsor Power | 3 | 01-26-2004 03:31 AM |
Bump stop on coil overs? | ciara | Windsor Power | 1 | 01-16-2004 11:08 AM |
What spring rate should I get for rear coil overs | ciara | Windsor Power | 0 | 12-24-2003 07:29 AM |
coil overs | faststang90 | Windsor Power | 0 | 04-20-2002 12:59 PM |
rear coil overs | faststang90 | Windsor Power | 0 | 03-04-2002 12:47 AM |