Torque Boxes while I'm at it?
 

I'm getting ready to have a panhard rod and a torque arm installed. As long as I'm down there weilding things, should I go ahead and weld the torque boxes up? How about axle tubes or anything else?

Thanks.

------------------
AIM: Some97Snake

Torque Box Reinforcements : YES
Axle Tubes: NO

------------------
Greg Banish
President, Detroit Speedworks, Inc.
'93 LX Turbocharged Road Racer
'00 Bad-Ass F150

Thanks!


--------
"Come see the bind inherent in the system! Come see the bind inherent in the stystem! Help! Help! I'm being repressed!"

-From Monty Python and The Quest For the Holy Suspension

[This message has been edited by 97snakedriver (edited 01-14-2001).]

Short an sweet baby. thats an answer http://www.mustangworks.com/interact...board/wink.gif the axles on an 8.8 are welded into the center section already, Just not completely welded like on a 9 inch. (guess its because the 8.8 axle tubes are pressfit also?)

About the torque boxes reinforcement, exactly what should be done?

------------------
92GT,SOLO RACER, COBRA BRAKES, R1 TIRES, GT40, GT40X HEADS 58CC, 24LBS, 70MM/65MM, E303, 4.10, MANY ROAD RACE MODS, CORVETTE, CAMARO, RX7 AND SUPRA SOLO EVENT EATER

killersracing.com

We use the Wild Rides Torque Box Reinforcements. (as seen in most Mustang magazines) Whenever possible, I prefer to weld the reinforcements, too.

------------------
Greg Banish
President, Detroit Speedworks, Inc.
'93 LX Turbocharged Road Racer
'00 Bad-Ass F150