04-11-2002, 05:57 PM
| #1 (permalink) |
| Registered Member  Join Date: Oct 2000 Location: Santa Lucia di Budoia, Italy
Posts: 217
|  Where do the spacers go on Pro3i C/C plates? Anyone have any ideas where the spacers go if the car is lowered 1 1/2" (BBK's)? These are the Pro3i plates aka hotparts.com aka Maximum Motorsport. Thanks a bunch, Hector
__________________ 86 GT T-tops |
|      |
|
04-12-2002, 09:31 AM
| #2 (permalink) |
| Moderator  Join Date: Dec 1999 Location: Livonia, MI, USA
Posts: 1,194
| I put mine "underneath" to give the strut as much travel as possible (before it bottoms out). Just watch the hood. Put a piece of clay on it, and lower the hood gently to make sure you got the clearance. Mine was ok. 
__________________ Darius Rudis, Moderator Corner Carvers Delight 1989 Mustang LX - Open Track Car http://www.dariusrudis.com |
|
| |
| Sponsored Links | |
| | |
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help woth installing groundpounder coilovers with BBK caster camber plates | ciara | Windsor Power | 0 | 01-10-2004 01:08 PM |
| best camber/caster plates | johnmcgt | Windsor Power | 3 | 06-11-2003 09:02 PM |
| crank shaft spacers | BilLster | Windsor Power | 0 | 04-24-2003 03:53 PM |
| Is anyone using PRO3I C/C plates? | LOCASH | Corner Carvers Delight | 4 | 02-20-2002 03:03 PM |
| caster/camber plates used with a strut tower brace | jtl | Windsor Power | 1 | 02-10-2002 10:31 PM |
Linear Mode
