Re: Stroker 347
Origianal 302 stroked to a 347, its a 1990 that was configured for speed density, so I had to buy a conversion to mass air. After spending that money I was a little upset when it still ran bad, so I looked deeper into it and found out it was running way lean.
So I have been told that I need at least 30lb injectors but to do that I need to upgrade the Mass Air to accomidate that. My question is will that be enough for a 347 and if so what Sensor should I go with? I don't want to buy all this and find out it still runs lean. What do you think? What is common on a 347 for injectors/mass air sensor.
Thank you for your help!
Mark
|