© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-16-2003, 01:56 AM | #1 |
Registered Member
Join Date: Nov 2002
Posts: 23
|
Quick Starter Install Question
1989 5.0 AOD w/ 135k
I just installed a PMGR starter. I just want to verify with someone that I set up the wires correctly: 1.) On the starter relay, I transfered the old starter wire to the terminal containing the (+) battery wire. So, this terminal (right hand terminal as you look down on the relay from the drivers side) has the battery wire, the old starter wire, and some other stuff. 2.) Connected new starter wire to the terminal that previously held the old starter wire. This terminal (left hand side) contains ONLY the new starter wire. The car starts up just fine; however, I don't notice much difference from my old Motorcraft starter. It makes a slightly higher pitched, pulsating noise. (I was under the impression the engine would start way faster and sound very different than my original.) I am probably being overly anal about this...I just wanna check with someone for piece of mind. Thanks, Evil Joe |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pressure plate install, quick question | bmxmon | Classic Mustangs | 1 | 06-02-2004 03:44 PM |
Putting in clutch pedal after starter install now produces very high pitched whine | crazypete | Windsor Power | 3 | 08-18-2003 08:51 PM |
Quick question, how much did you pay for your H-pipe install from a shop? | 96_4.6 | Blue Oval Lounge | 5 | 08-02-2002 12:17 AM |
Help Quick Please! Ring gear install question??? | 90'5.0 Conv | Windsor Power | 5 | 05-03-2002 07:53 PM |
help quick, 93 starter in 87GT problems | fiveohpatrol | Windsor Power | 2 | 06-21-2001 06:22 AM |