MustangWorks.com : Ford Forums - View Single Post

worked95 · 04-21-2005, 06:31 PM

I added a set of Edelbrock Performer heads ...what a difference!! The heads have the 1.90 in intakes with a 3-angle valve job.
After a while i installed the Ford E-303 cam. I have an Automatic (a mistake on my part when I bought the car) and the cam does hurt low end but above 3000 RPM it pulls great to about 5900.
I also have the usual mods: underdrive pulleys, 3.73 rear, headers, Cobra intake, 73mm Mass Air, 65 mm Throttle body, 1.70 roller rockers and high flow cats but the biggest difference was in the heads. By the way the 1.7 roller rockers made a noticeable difference above 2800 RPM. I instaled these just before I installed the cam.

04-21-2005, 06:31 PM	#11
worked95 Registered Member Join Date: Apr 2005 Posts: 6	Re: HELP NEw AT THIS/radio and clock issue I added a set of Edelbrock Performer heads ...what a difference!! The heads have the 1.90 in intakes with a 3-angle valve job. After a while i installed the Ford E-303 cam. I have an Automatic (a mistake on my part when I bought the car) and the cam does hurt low end but above 3000 RPM it pulls great to about 5900. I also have the usual mods: underdrive pulleys, 3.73 rear, headers, Cobra intake, 73mm Mass Air, 65 mm Throttle body, 1.70 roller rockers and high flow cats but the biggest difference was in the heads. By the way the 1.7 roller rockers made a noticeable difference above 2800 RPM. I instaled these just before I installed the cam.