keyless entry
 

Can anyone help? I've got a 95 6cyl mustang with the whole keyless entry deal, but I think i need to reprogram it. Anybody know how to do that exactly?:confused:

What, does it not work... okay, I'll assume it doesn't.

Try removing the negative battery cable for a second and reconnnecting it.

thanks much. I'll try it and see what happens.

I think they have batteries in the hand held activator. If removing the negative battery cable does not work you might try replacing the battery in the activator. 1995....hmmm maybe the battery is dead.

This is not the keyless entry with the number pad on the door is it? I din't think Mustangs had those. I had a T-bird that did though.

Is it stock or is it a Viper or something after market. Those can be more complicated.

Its stock and I just replaced the batteries in the hand held activator.

Is it working now?

nope nope. neither changing the batteries nor removing the negative cable worked. I guess I'll just go take it up to Ford and have them reprogram it.

If your batteries are good (they are 3 volt) follow this procedure to program your transmitters (key fobs). Turn the ignition to RUN or ACC. Momentarily jump the pins in the programming connector located in the left rear quarter panel area, it's a two pin connector behind the trim panel. All of the doors will lock and then unlock confirming that you are in programming mode. Press any button on 1st transmitter. The door locks will cycle to confirm programming. Press any button on 2nd transmitter (if you have another, you can program up to 4 transmitters) and locks will cycle again. Turn the ignition off. The locks will cycle once again to indicate the end of programming mode.

gin

Whoa..... Sounds like it might work.... Please post an let us know what happens