If your batteries are good (they are 3 volt) follow this procedure to program your transmitters (key fobs). Turn the ignition to RUN or ACC. Momentarily jump the pins in the programming connector located in the left rear quarter panel area, it's a two pin connector behind the trim panel. All of the doors will lock and then unlock confirming that you are in programming mode. Press any button on 1st transmitter. The door locks will cycle to confirm programming. Press any button on 2nd transmitter (if you have another, you can program up to 4 transmitters) and locks will cycle again. Turn the ignition off. The locks will cycle once again to indicate the end of programming mode.
gin
Last edited by gin; 04-09-2004 at 10:28 PM..
|