Pinoneer DEHP2000 and 12" Sound Stream
 

I have a Pioneer DEHP2000 deck which I've lost the manual for.

My wife has a 12" sound Stream Sub woofer (boxed) and an Alpine 4X25W +80W sub. I was thinking about adding the Alpine Amp and using the 80W sub channel to power the 12" sub to my 95 GT.

Question: I have the Mach 460 Sound system. Is there outputs from my deck for this AMP (like I said, I've lost the manual. If you know where I can find one online PLEASE let me know).

I know the 80W is not a lot for the 12"sub, but it's more bass than I have now.

Thanks.

I you have a aftermarket HU, then yes you can hook up that amp.

Just curious to know how the speakers are hooked up with the Mach 460.

Are the 2 front speakers (door and upper tweeter) considered the same speaker? I know there are 2 amps for the rear speakers, do they just run from the output of the deck or do they dues RCA outs?

Thanks. Tire you are the man! ;)


Oh do you know where I could find some information about my deck? I can't even set the freaking time on it.

No the front two speakers are not considered one. They both get different freqences and are powered by different amps.

The amps in the Mach 460 system are non-adjustable units that use speaker-level imputs.

Here's kind of a break down of the amps for ya. The front amp is a 60-watt(30x2) parametrically equalized amplifier located in dash console under radio/CD player. This amp powers the front and rear high frequency (Mid/Tweeters 2 1/2") speakers and sends the low frequency signal via a series fader to the rear amps. The rear amps (2x45w Nom. x2) provide a mono bass signal to the mid/woofers. These two amps power the front and rear low frequency (Mid/Woofers 6"x8") speakers

Unless you are unhappy with your Mach 460 system(other than bass) I would just leave the stock amps in place and just use the 80W sub output to power the sub. Or you could purchase another amp, if you go that route I would suggest a JBL BP300x1, you can get one from Scala1 on E-bay(bought a lot of my stuff from him) for 132 bucks. Not bad for a amp that pushes a true 300 watts.

Here's how to set the time. With the source off (i.e., the radio/cd unit is turned off), press and hold the Func button for 2 seconds. The display will light and the hour will be flashing. Use the up and down arrows to adjust the hour setting. Move to the minutes setting by pressing the right arrow. Then adjust the minutes by using the up and down arrows. End the settings mode by pressing the source button

I like the sound of the Mach 460 system, and I'd like to just get one 10" sub and a 200-300W amp, but right now any extra money goes to go fast goodies. I just happen to have the 12" sub and 80W amp available, that's why I was thinking of going this way. I think 80W is not near enough power for a 12" sound steam, but when the wife bought the system she did not listen to me and listened to some dumb a** punk kid at the store :rolleyes:

Thanks tire

What about this baby http://cgi.ebay.com/ws/eBayISAPI.dll...tem=1377350053

Just bridge it out and you've got 150rms watts. You can't beat that for 88 bucks. This guy is legit, I've bought a lot of stuff from him, so has MidNitBlu5.0.

Yes Scala1 is very legit. I know a few people from sounddomian and of course my self who have used him a couple times with no problems.

HEEHEE Tire ya da man Cam tire said it all sorry I haven't been on in a few days!!!! See ya guys!;)