[ultraflo]

The numbers on the bottom of the relay that Andy is referring to are as follows:

30 -- to +12v batt. source
85 -- to ground
86 -- to toggle switch
87 -- to pump

You should maybe step up to at least 10g wire if you have to go some distance... putting the relay under the dash should be okay, with the bigger wire. And you can easliy route the wiring inside the interior, out through a grommeted hole near the pump.


The 'dashes' located around the numbers below represent what the bottom view of the relay should look like:

....87_
..87A_
86| .... |85
....30|