View Single Post
Old 09-03-2005, 04:59 PM   #5
Meotchh
Registered Member
 
Meotchh's Avatar
 
Join Date: Jul 2005
Location: SoCal
Posts: 44
Default Re: dome light always on

Check out the wires at the GEM (Generic Electronic Module) is located above the driver kick panel. You are looking for yel/black (L), gray/red (R) 20Pin plug, pin 13 & 5 at GEM.

These wires should only show a short to gnd when the door is open. If they are showing a short to ground with the door closed then you can check your pin switch.

Now since I don't know your abilities I will ask a simple question. Do you know how to use a DMM (DigitalMultiMeter)? If so this will be simple for you to figure out. If not I would recomend you go visit someone that knows how.
__________________
L8R

Meotchh
Meotchh is offline   Reply With Quote