Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-20-2002, 08:18 PM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Metairie, La. USA
Posts: 132
|
Battery Relocation - parts question
PLease check this diagram and see if this wiring for the battery switch will pass tech:
 I also need to know if 4AWG wire will be enough for the alternator to the distribution block.
__________________
Engine: 1990 5.8 / Edelbrock Performer set-up MSD ignition Suspension: Maximum Motorsports Caster-Camber Plates / Maximum Motorsports adjustable lower control arms / FRPP heavy duty upper control arms / Tokico Illumina Shocks and Struts / Ground Pounder Coil Over conversion kit front / Steeda cross brace sub-frame connectors / Drivetrain: Tremec 3550 trans / Steeda Tri-Ax shifter / Spec Stage II clutch and pressure plate / Spec aluminum flywheel / 5.8 in the hole |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Battery Relocation - parts question | Stang951 | Racer's Club House | 2 | 07-21-2002 08:04 PM |
| Battery Relocation - parts question | Stang951 | Windsor Power | 2 | 07-20-2002 08:51 PM |
| question about battery size and stumbling | HopingForAGT | Windsor Power | 3 | 01-28-2002 11:01 PM |
| Battery relocation tips | 93GT50 | Windsor Power | 4 | 11-12-2001 11:14 PM |
| Battery Disconnect Install Question? | Sparkplug | Windsor Power | 7 | 07-29-2001 12:29 AM |