![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
Registered Member
Join Date: Jun 2001
Location: Belmar, NJ
Posts: 52
|
![]() When you run the amp use 4 guage wire for the power and ground. Run the power wire down on side and the remote down the other side of the car. Remote does not have to be anything more than 16 guage. Ground should be less than 2 feet. The amp should be switched to HPF to much low end will destroy the factory speakers. Be very careful on how much the gain is up. Start with it a 1/4 of the way up and go from there. I found tapping into the cigarette power for the remote works good (if it is hooked up to the ignition and not a constant power) as your remote
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
TFI module part # | GhettoPop | Windsor Power | 2 | 02-12-2004 01:34 PM |
Looking for Bosch part #'s! | chris91LX | Windsor Power | 0 | 12-28-2001 06:58 PM |
Lightning Audio | Power | Audio, Security, & Electronics | 2 | 06-16-2001 03:21 PM |
Need help finding Ford part numbers | Capri306 | Windsor Power | 0 | 03-30-2001 10:13 AM |
Hard to locate part for 83 stang help!!! | 83stanger | Small Ponies | 0 | 03-02-1999 08:52 AM |